SHT30 Temp, Humidity & Barometric Pressure Sensor with Protection Filter for Seaside Use(WH65, WH65LP, WS69) (Please check the notes below before purchase.)
Couldn't load pickup availability
Before Purchase Notice:
Please check the sensor ID of your WS69/WH65 device (found on the device body) before purchasing. If the ID is two digits, this module is not compatible.
Installation Steps:
1. Open the insulation cover on the top.
2. Remove the temperature and humidity module that needs to be replaced
3. Replace it with a new temperature, humidity and pressure module. Make sure that the module is securely fastened in place.
4. Install the protection filter for the temperature, humidity and pressure module, and close the insulation cover.
Compatibility Instructions
for all ecowitt network consoles
Please refer to the table to choose the correct sensors and consoles before checkout.
Note:
1) "1/4/8/16" = max number of sensors supported per console (excluding accessories).
2) Upload only = sensor readings shown only in the Ecowitt app and cloud (www.ecowitt.net).
3) Firmware (e.g. V1.9.6 / V2.0.2) = gateway/console must run this version or newer.
