SHT30 Temperature, Humidity, and Pressure Sensor with Protection Filter for Seaside Use (WN90LP, WS90)
Couldn't load pickup availability
Note: If your device is WS90 and you're using the heating power supply, please purchase the module with temperature compensation: SHT30 Temp & Hygr with protection filter and compensation function for WS90 only
1. Open the insulation cover on the top.
2. Remove the temperature and humidity module that needs to be replaced
3. Replace it with a new temperature, humidity and pressure module. Make sure that the module is securely fastened in place.
4. Install the protection filter for the temperature, humidity and pressure module, and close the insulation cover.
Compatibility Instructions
for all ecowitt network consoles
Please refer to the table to choose the correct sensors and consoles before checkout.
Note:
1) "1/4/8/16" = max number of sensors supported per console (excluding accessories).
2) Upload only = sensor readings shown only in the Ecowitt app and cloud (www.ecowitt.net).
3) Firmware (e.g. V1.9.6 / V2.0.2) = gateway/console must run this version or newer.
